TMS320C6474
SPRS552F – OCTOBER 2008 – REVISED JULY 2010
www.ti.com
7.15 Timers
The timers can be used to: time events, count events, generate pulses, interrupt the CPU, and send
synchronization event so the EDMA3 channel controller.
7.15.1 Timers Device-Specific Information
The device has six general purpose timers: Timer0 to Timer5, each of which can be configured as a
general purpose timer or a watchdog timer. When configured as a general-purpose timer, each timer can
be programmed as a 64-bit timer or as two separate 32-bit timers.
Each timer is made up of two 32-bit counters: a high counter and a low counter. The timer pinout is
described in the next section.
7.15.1.1 Timer I/O Selection
Not all timer inputs and outputs are pinned out of the device. The six timers have a flexible (e.g. software
controlled) selection of timer inputs and outputs. At the chip level there are four timer pins, two input pins
(TIMI[1:0]) and two output pins (TIMO[1:0]). Each timer input can be configured to be driven by either of
the timer input pins, or by an FSYNC event (FSEVT[3:2]). Each output pin can be driven by any of the
timer outputs. This is programmable through software via the Timer Pin Manager Block, as shown in the
Figure 7-38
. Not shown in the figure is the logic that gates the timer resets that are routed to the PLL
controller, shown in
Figure 7-39
.
158
Peripheral Information and Electrical Specifications
Copyright © 2008–2010, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Link(s) :
TMS320C6474
Summary of Contents for TMS320C6474
Page 209: ...PACKAGE OPTION ADDENDUM www ti com 25 Sep 2010 Addendum Page 2 ...
Page 210: ......
Page 211: ......
Page 212: ......