www.ti.com
5.67 Port Response Time-Out Control CSR (SP_RT_CTL)
SRIO Registers
The port response time-out control CSR (SP_RT_CTL) is shown in
Figure 130
and described in
Table 138
For additional programming information, see
Section 2.3.3.3
and
Section 2.3.3
.
Figure 130. Port Response Time-Out Control CSR (SP_RT_CTL) - Address Offset 1124h
31
TIMEOUT_VALUE
RW-FFFFFFh
8 7
0
TIMEOUT_VALUE
Reserved
RW-FFFFFFh
R-00h
LEGEND: R/W = Read/Write; R = Read only; -n = Value after reset
Table 138. Port Response Time-Out Control CSR (SP_RT_CTL) Field Descriptions
Bit
Field
Value
Description
31–8
TIMEOUT_VALUE
000000h
Timeout value for all ports on the device. This timeout is for sending a packet to
to
receiving the corresponding response packet. Max value represents 3 to 6
FFFFFFh
seconds. The timeout duration can be expressed as:
Timeout = 15 x ((Prescale Value + 1) x DMA Clock Period x Timeout Value)
where Prescale value is set in PER_SET_CNTL (offset 0020h) and the Timeout
value is the decimal representation of this register value. For example, given a
400-MHz DMA, a Prescale Value of 4, and a Timeout Value of FFFFFFh, the
Timeout duration would be:
Timeout = 15 x ((4 + 1) x 2.5 ns x 16777216) = 3.15 s
7–0
Reserved
00h
These read-only bits return 0s when read.
Serial RapidIO (SRIO)
198
SPRUE13A – September 2006
Submit Documentation Feedback
