The TPA0242 Audio Power Amplifier Evaluation Module
3-3
Details
3.2
The TPA0242 Audio Power Amplifier Evaluation Module
The TPA0242 audio power amplifier evaluation module is powered by a
TPA0242 stereo power amplifier capable of delivering greater than 2 W of
continuous power per channel into 3-
Ω
loads. The amplifier IC can be operated
in either the BTL or single-ended output mode. The evaluation module
includes control inputs for shutdown, selection between two sets of stereo
inputs, and switching between single-ended and bridge-tied load output
modes.
The module can be used with the TI plug-n-play audio amplifier evaluation
platform (Figure 3 –1) or wired directly into circuits or equipment. The module
has single in-line header connector pins mounted to the under side of the
board. These pins allow the module to be plugged into the TI platform, which
automatically makes all the signal input and output, power, and control
connections to the module.
The module connection pins are on 0.1-inch centers to allow easy use with
standard perf board and plug board-based prototyping systems. Or, the EVM
can be wired directly into existing circuits and equipment when used stand-
alone.
The module appears in Figure 3–2 and its schematic is shown in Figure 3 – 3.
Figure 3–2. TPA0242 EVM
GND
ROUT+
ROUT–
SE/BTL
S1
SHUTDOWN
GND
LOUT–
LOUT+
C11
C2
C13
VDD
GND
L IN+
GND
L LINE–
L HP
VDD
GND
R HP
R LINE–
GND
R IN+
C10
+
TPA00242 EVM Board
SLOP275
U1
+
TEXAS
INSTRUMENTS
R2
R1
PCBEEP
C1
C12
C6
C5
C4
R3
S2
C7
C8
C9
C3
SHUTDOWN
R4
S3
S4
HP/LINE
Summary of Contents for TPA0242
Page 4: ...iv...
Page 10: ...1 4 Introduction...
