Using TPA3250D2EVM in Different Output Configurations
NOTE:
INA
and
INB
are the inputs for PBTL and
INC
and
IND
are grounded for PBTL operation.
3.3
Single-Ended (SE) Output (4.0) Operation
Configure the EVM as follows for 4 single-ended operations:
•
Set
J6
to H and
J5
to H.
•
Connect speaker/power resistor (4–8
Ω
) positive terminal to OUTA and remove jumper
J22
.
•
Connect speaker/power resistor (4–8
Ω
) positive terminal to OUTB and remove jumper
J23
.
•
Connect speaker/power resistor (4–8
Ω
) positive terminal to OUTC and remove jumper
J24
.
•
Connect speaker/power resistor (4–8
Ω
) positive terminal to OUTD and remove jumper
J25
.
•
Set both
J4
and
J19
jumpers position to DIFF.
•
Connect input to female RCA jack input A (
BLACK
) for OUTA speaker.
•
Connect input to female RCA jack input B/AB (
WHITE
) for OUTB speaker.
•
Connect input to female RCA jack input C (
YELLOW
) for OUTC speaker.
•
Connect input to female RCA jack input D/CD (
RED
) for OUTD speaker.
spacer
spacer
spacer
spacer
spacer
NOTE:
The performance of the TPA3250D2EVM/TPA3250D2DDV is dependent on the power
supply. Design the power supply with margins that can deliver the needed power. In low-
frequency applications additional bulk capacitance may be needed. Replacing the bulk
capacitors on the TPA3250D2EVM with 3300 µF or more capacitance may be necessary,
depending on the power supply used.
8
TPA3250D2EVM
SLVUAM9 – December 2015
Copyright © 2015, Texas Instruments Incorporated
