19
7.
Two hand operation
.
8.
Warning:
If the log does not split immediately, do not force it by maintaining the
thrust for more than a few seconds. This can damage the tool. It is better to try
repositioning the log on the splitter or setting the log aside.
9.
Stack as you are working
. This will provide a safer working area, by keeping it
uncluttered you avod the danger of tripping or damaging the machine.
10.
Remember to tighten the air escape valve (14) when you have finished
splitting.
Recommended size of wood to be split
The diameter of the log is only indicative. A small piece of wood can be difficult to split if it
has knots or if its fibres are very tough. A larger piece of wood can be split if its fibres are
smooth and loose.
Never force the log splitter to split more than 5 seconds with the cylinder under pressure
in order to split excessively hard wood. Overheated oil under pressure may damage the
machine. It is very important that if the log splitter does not split in the first attempt,
please stop the machine and rotate the log 90 degrees. If the wood still cannot be split,
it means that the hardness of the wood exceeds the capacity of the machine and it must
be rejected in order not to damage the log splitter.
Recommended hydraulic oil
We recommend the following oil for the hydraulic cylinder :Texaco Rando HDZ32
Article
number:
90306479
Or oil with corresponding viscosity.
When it is safe to start,
press the engine start switch
(F) with one hand and the
handle (C) with the other
hand.
The log pusher (B) will
compress the log and push
it against the wedge (J),
which splits the logs. When
the logs have been split you
shall release both the
engine start switch (F) and
the handle (C), this will allow
the log pusher (B) to
withdraw.
