www.texas.dk
17
7. Adjustment of cutting height
8. Edge guide
The cutting height has 3 positions: 10, 20, and 30 mm.
To adjust the height turn the adjustment knob 5-6 full turns.
It should not be removed.
Press the knob towards the machine and at the same time
move the front wheel to the other side. Lift or lower the arm
to the new position.
Pull the knob back out and tighten when the arm is in the
correct position.
The edge guide is used when working against solid material like
a paved surface to prevent the blade from being damaged
against the hard surface.
Press the handle to the side (towards the centre of the ma-
chine) and then downwards. Then press it to the side again.
The edge guide is now active.
When the edge guide lever is up the edge guide is not in use.
