www.texas.dk
18
9. Using the machine
10. Changing the blade
Place the edge cutter on the side with the blade turned
up. Make sure the machine is placed on a clean surface
to prevent dirt from getting into the air intake of the en-
gine.
Remove the spark plug cap.
Hold firmly a spanner on the blade flange loosen the
lock nut with another spanner.
Remove the blade.
Check the area for wiring, rock and other parts that may be
damaged or make damage to the machine.
Adjust the cutting height to 20 mm. If the ground is very hard
or very soft you may need to change the adjustment to 10 mm
and 30 mm.
Use the edge guide to keep the direction.
Slowly lower the edge cutter while pressing the throttle.
Slowly push the machine forward keeping the direction.
If cutting against a paved surface use the edge cutter by
pressing it lightly against the paved surface. See above how
to active the edge cutter.
