www.texas.dk
16
Trouble shooting
PROBLEM
POSSIBLE CAUSE
SOLUTION
1. No spark.
Check the spark plug. Take off the spark plug,
place the spark plug cap on the spark plug and
put the spark plug on the metal cylinder. Pull
the starter and check if there are sparks on the
top of the spark plug. It there are no sparks
repeat the procedure with a new spark plug.
2. No fuel.
Press the fuel primer. If the problem persists,
contact your local dealer.
3. ”Drowned” engine.
Remove the spark plug and turn the trimmer so
that the spark plug hole faces the ground.
Switch the choke to “RUN” and pull the starter
10-15 times. Clean the spark plug and fit it
again. You might also replace the spark plug.
Pull the starter 3 times with the choke switched
to ”RUN”. If the engine does not start, move the
choke to “Choke” and normal starting procedure
is used. If the engine still does not start, repeat
the procedure with a new spark plug.
The engine does not
start.
4. The starter must be pulled
harder than when the machine
was new.
Contact your local dealer.
The engine starts but
does not accelerate.
The carburettor should be ad-
justed.
Contact your local dealer.
The engine starts but
can only run on full
power and on half
choke.
The carburettor should be ad-
justed, repaired or cleaned.
Contact your local dealer.
1. Check the mix of the petrol
and oil.
Use new fuel with the correct mix.
2. The air filter is dirty.
Clean or replace.
The engine does not
run on full power and
smokes heavily.
3. The carburettor should be
adjusted.
Contact your local dealer.
The engine starts, runs
and accelerates but
can not run idle.
The carburettor should be ad-
justed.
Contact your local dealer.
1. The trimmer is not used on full
power.
Use full power.
2. Check the mix of the petrol
and oil.
Use new fuel and correct two-stroke mix.
3. The air filter is dirty.
Clean or replace.
Oil leaks from the ex-
haust.
4. The carburettor should be
adjusted.
Contact your local dealer.
