17
Mounting- and operation
Your lawnmower has been manufactured accordingly to the latest safety
specifications. This includes a brake system, which will stop the engine and knife
within 5 seconds, when the brake is activated. Any safety precaution is only useful
when it is followed therefore follow these description when you mount your
lawnmower.
Identification of parts
See Figure 1
A. Starting cord
B. Discharge guard
C. Grass catcher
D. Height adjustment
F. Oil lid / Oil inlet
G. Petrol lid / inlet
H. Air filter
I. Primer bulb
J. Spark plug cap
K. Handle for wheel drive
L. Stop handle
M. Throttle control lever
N. Garden hose nozzle
Grass collector
Assemble the grass catcher as shown in Figure 2
Mount the black metal bracket inside the cover. Attach the black collecting tray to the
cover, as shown. Clip the white clip attached to the bag over the black bracket.
Mounting of the handle
The lawn mower is supplied almost fully assembled.
Remove the lawn mower from the box and pull Check that the cables do not become
trapped.
Once the control is unfolded, tighten the four wing nuts Figure 3
Tighten the handle Wing nuts Figure 4
Cable
The clutch cable (Figure 5A) will from delivery be dismounted from the metal bracket
(Figure 5B). To fit the cable, the metal bracket must be pulled out of the hole in left side of
handlebar.
Then fit the s-hook from cable into the hole in metal bracket. At last, the metal bracket
must be pushed back into the hole in handle bar. Check that it works before start engine.
Mulching
When using mulching, the mulching plug needs to be fitted into the rear discharge hole.
Notice, that when using mulching, the collector box must always be dismounted.
The rear discharge guard will go down at keep the mulching plug in place.
