INS524-4 8/53
1.0 Installation GB
The Premier keypad is only compatible with Texecom Premier control panels. Any combination of Premier Elite keypads can be
used. Keypads can be connected serially (daisy chain), in parallel (star) or any combination of the two.
1.1 Wiring
It is strongly recommended that the system is completely powered down (mains and battery) before wiring a keypad. Connect
the keypad to the control panel using 4-core cable as follows:
The networks are made up of four terminals incorporating power and data. To ensure correct operation, all four terminals on the
device must be connected to the corresponding terminals on the control panel or previous device.
Keypads can be connected using 4-core cable. However, it is recommended that 6 or 8-core cable is used as the spare cores can
be used to ‘Double Up’ on the power connections if needed.
Standard 7/0.2 alarm cable can be used for most installations. However, under certain conditions it may be necessary to
use screened cable.
Please refer to the Control panel Installation Manual for details on wiring, programming and testing the zones, outputs
and loudspeakers.
1.2 Selecting an Address
Each keypad must be assigned a different address using the DIL switches located on the left hand side of the PCB. The table
below shows the keypad addressing:
Summary of Contents for Premier Elite FMK
