User Guide
INS046-8
7
Enter your 4 digit code
!!!!
.
Press
)
. All the zone lights
will illuminate.
Press
&
followed by the number corresponding to the
desired event,
#
being most recent,
/
being least recent (e.g. to
recall the second most recent event enter
&$
). On completion
press
*
, all the zone lights will illuminate.
Press
*
again. The
system will return to unset and all the zone lights will turn off.
To Walk Test the System
The control panel has a Walk Test facility to check the operation of the
system's detection devices.
Enter your 4 digit code
!!!!
. The Unset
light will flash.
Press
)
. All the zone lights will illuminate.
Enter
,.
.
Initially all the zone lights will turn off and the control panel will sound the
quiet exit tone. When any zone is opened the control panel will illuminate
the corresponding zone light. The control panel will in addition sound a
repeating series of bleeps corresponding to the open zone number (i.e.
Zone 1 bleeps once, Zone 2 bleeps twice, etc.). If more than one zone is
open the bleeps will correspond to the highest zone number (e.g. if Zone 2
and Zone 6 are open the control panel will bleep 6 times).
Conduct a walk test by triggering each of the system’s detection devices
in turn and check that the control panel registers the corresponding
zone as open. To terminate Walk Test
press
*
. All the zone lights
will illuminate.
Press
*
again. The system will return to unset and
all the zone lights will turn off.
To Change Your Code
Before changing your code, it is vital that you memorise or
write down the new code you are about to program. Failure to
remember your new code will require an engineer visit to
re-program a new code for you. This may incur a call-out charge.
Enter your existing 4 digit code
!!!!
. The Unset light will flash.
Press
)
. All the zone lights will illuminate.
Enter
.,
. All the zone
lights will turn off.
Enter your new 4 digit code
!!!!
. Zone lights
1, 2, 3 and 4 will illuminate in turn as each digit of the new code is
entered.
Press
)
. The system will chime to confirm the new code
has been accepted and all the zone lights will illuminate.
Press
*
.
The system will return to unset and all the zone lights will turn off.
If Your System is Due for Maintenance
The system has a service timer which may be programmed by the
installer to give a reminder when maintenance is due. The reminder may
be either turning Chime on or preventing the system from being set.
Chime may be turned off as previously described. In either case contact
your installer.
!
