5.3 SP number
(Note:The corresponding relationship between the tools and the SP
numbers are slightly different for different models.Here is just a
brief introduction.Please consult the Strima technician for the
specific corresponding relationship among the tools,SP numbers and the
tool holders.)
(1)One cutter head machine:The machine that all tool holders mounted
on one fixed plate.
【
SP1
】
:Mark pen
；
【
SP2
】
:Creasing wheel tool/Punching tool
；
【
SP3
】
:Big-knife V-cut tool/Punching tool
；
【
SP4
】
:oscillating cutting tool /Driven rotary tool /Kissing cutting
tool/Pneumatic oscillating cutting tool/Universal cutting tool
；
【
SP5
】
:Small-knife V-cut tool
；
【
SP6
】
:Milling tool
；
【
SP7
】
:Mark point/Mark line
；
【
SP0
】
:Not to process
(2)Two cutter heads machine:The machine that all same tools holders
mounted on two separated fixed plate.For example, the cutter head1 and
cutter head2 all are installed the oscillating tool and the mark pen:
(Note:For the one cutter head machine,the knife tool holder at the Y+
position called Head1
，
the knife tool holder at the Y- position called
Head2
；
For the two cutter heads machine
，
the cutter holder at the Y-
position called Head1
，
the cutter holder at the Y+ position called
Head2)
①
Cut single line graph in X direction, only one cutter head can be
used for cutting.
A.
Set the Head1 and Pen1 to work
，
the SP number of Head1 is SP4
，
the
SP
number of Pen1 is SP1,as shown below
：
Summary of Contents for XYZ 2518
Page 1: ...TEXI XYZ 2518 MANUAL...
