(2)After the driven rotary tool bar is placed into the tool holder,
tighten the fixing ring and fix the slot to the iron rod at the
figure.Tighten the screws at the connection between the tool bar and
the tool head in the rightmost figure, and insert the cable of the
tool into the left socket of cutter head.
(3)Knife depth setting
，
drop the knife tool to an appropriate
position, turn the black nut which is used to fixed the knife by
hand, and when the edge of the round knife touches the felt, then try
cutting. If the knife depth is slightly shallow or too deep, the
knife depth can be fine-tuned according to the
7.1->(6)->
⑧
.
(4)Over-cutting,the over-cutting is controlled by extension.
Extension is divided into down extension and up extension. When the
extension value is positive, it means to cut a distance more. If it
is negative, it means to cut a distance less.Press
to
change the data in the red box below to fine-tune:
（
Note: This method is also applicable if the remaining tools also
have a problem of over-cutting
）
7.4 Universal Cutting Tool(Drag Knife)(SP4, cut
，
Head1
；
SP2,
Tcut,Head2)
(1)The knife must be placed at the bottom of the groove, and the
cutting edge is at the same side with the set screws.
Summary of Contents for XYZ 2518
Page 1: ...TEXI XYZ 2518 MANUAL...
