(Note:The value of the
“
v angle
”
must be the same as the angle of the
actual installation position of the knife.
）
C.
Press
to to return to Vcut page
，
when setting the knife depth,
just let the tip of the knife enter the corrugated paper 0.2-0.3mm.
D.
Press
，
The machine will cut two vertical lines in X direction
，
if it cut like this:
or
,press
to fine-tune its parameter
till it can cut like this
.
E.
Press
,The machine will cut two transverse lines in the Y
direction. If the two lines do not coincide,press
to
fine-tune its parameter till the two lines coincide.
⑤
Knife depth setting
，
drop the tool to the thickness to be cut.
⑥
→
→
→
，
fine-tune the
data to adjust the over-cutting.
(2)Small knife V-cut tool(SP5
，
Vcut,Head2)
(Note:SP3 must be used during debugging)
①
Installation of the knife
②
Make sure that the value of the W1 axis is 0.00,and the cutting
edge of the knife must face the X+ direction,tighten the fixing ring
and set screws.
Summary of Contents for XYZ 2518
Page 1: ...TEXI XYZ 2518 MANUAL...
