The
“
test angle
”
and
“
test offset
”
page,press
→
，
as shown below:
8.1 Test Angle
(Note:1.Before testing the angle, the knife depth must be set first,
and as long as the mark can be cut on the material.2.Before testing
angle, a piece of material should be laid first, such as corrugated
paper, KT board, soft glass, etc.)
(1)Test Angle
①
Press
to change it to
。
②
Press
,the oscillating knife cutting tool will cut a cross,
judge whether the angle of oscillating knife cutting tool is correct
according to the included angle of every two lines of the cut cross,as
shown below:
Summary of Contents for XYZ 2518
Page 1: ...TEXI XYZ 2518 MANUAL...
