A1&A2 of the No.1 AC contactor.
B.
Connect the 220V power supply cables to the 2/T1 and 6/T3 of the
No.1 and No.2 AC contactors separately
(Note:No.5 and No.6 are connected
to the 220V cables.You need to prepare 220V power supply cables by
yourself)
C.
Connect the 220V Power Cable to the 220V power supply socket
(Note:The 220V power supply cables which are connected to the
distribution box must can bear at least 10KW power, the 220V Power
Cable which is sent with the machine is only supply the electricity to
the machine and control box, and the power of the machine is about
2500W)
②
Output
A.
Connect the aviation plug of the Signal Cable to the
“
Air Pump
”
port on the machine.
B.
Connect the two groups of Vacuum Pump Power Cables to 1/L1 and
5/L3
(Note:No.3 and No.4 of the AC contactors are connected to the
vacuum pumps)
of No.1 and No.2 AC contactors separately, and connect
the other end of each vacuum pump power cable to No.2 and No.3 feet or
No.1 and No.3 feet of each vacuum pump separately,as shown below:
(2)Vacuum Pump and Returning-air Box of the Auto-feeding Digital
Knife Cutting Machine.
(Note:There is no returning-air box and Part B
for the non auto-feeding model machine.)
Summary of Contents for XYZ 2518
Page 1: ...TEXI XYZ 2518 MANUAL...
