B.
Take the selection of 0.1mm inching step as an example.Press
for one time
，
it can increase 0.1mm knife depth,that is, if the current
knife depth is 50, after pressing one time
, the knife depth will
be 50.01, and there is no need to press
.
C.
Press any of these two buttons to test again
，
If the
material is cut through and the felt is not damaged,that means the
knife depth is reasonable.
⑨
Knife depth adjustment is completed, other tool depth adjustment is
similar
7.2 Pneumatic Oscillating Cutting Tool
（
SP4, cut,Head1
）
(1)The knife must be placed at the bottom of the groove, and the
cutting edge is at the same side with the set screws.
(2)Make sure that the value of the W axis is 0.00,and the cutting
edge of the knife must face the X+ direction,tighten the fixing ring
in the leftmost figure, and insert air tube into the left air nozzle
of the cutter head.
(3)Knife depth setting
，
please refer to
7.1->(6)->
④
->Method Two and
7.1->(6)->
⑤⑥⑦⑧
7.3 Driven rotary tool
（
SP4, cut
，
Head1
）
(1)Remove the black nut in the left picture, then insert the knife,
and finally fix it with a hex-wrench and a fork-wrench.
Summary of Contents for XYZ 2518
Page 1: ...TEXI XYZ 2518 MANUAL...
