(3)Knife depth setting
，
achieve half-cut effect
①
Adjust the black knob of the tool bar so that the expansion distance
of the part of the tool head is approximately the same as the material
fluctuation height.
②
Drop the tool bar until the tool head contacts the felt, and now,
drop the tool bar about 1mm.
③
Test cutting effect
，
if the cutting effect is not achieved, it is
necessary to fine-tune the missing part of the tip or the knife depth
data in the panel.
7.6 Creasing Wheel Tool
（
SP2,Tcut,Head2
）
(1)Introduction to the structure
(2)Tighten the fixing ring and the set screws
The set screws which are at the X+ direction can be tightened as the
following steps:
①
Press
“
work
”，
press blank between Z and W to switch the W to W1
(W
is the rotary axis of Head1
，
W1 is the rotary axis of Head2)
，
as
shown below:
②
Change 500 to 180
，
as shown below:
Summary of Contents for XYZ 2518
Page 1: ...TEXI XYZ 2518 MANUAL...
