to the distance between the red dot and the cross center;Second,press
the arrow buttons in the below figure to move the red dot to the cross
center position.
(3)When the red dot is at the cross center,press
to save the
data.
9.Maintenance
Cycle
Item
Illustration
Day
Tool holder
Take all tools out of the holder before
going off work every day
Clean the knife clamp part
Wipe it with the clean cotton cloth
Clean the surface of the
machine
Clean with air gun and rag
Check the drag chain slot
Make sure that the drag chain slot is
free of sundries and noise
Check the operation in the X
and Y directions
Running without any noise before cutting
Clean the X and Y rails and
add grease
Wipe rails with the clean cloth and press
the handle of the oilcan for 1-3 times
Clean the tools
Use an alcohol rag to remove residue from
the tool
Check the cutter head and the
tools
Before starting work, check whether the
cutter head and the tools can be operated
normally
Check the oil and water in
the air compressor
Drain water and oil through air compressor
drain valve
Check the total pressure The standard air pressure is 0.6MPa, if
Summary of Contents for XYZ 2518
Page 1: ...TEXI XYZ 2518 MANUAL...
