54
Figure 3-12
Real Temperature Setup
1.
Selet a type and matched an adaptor correctly as shown in
Figure 3-13
.
2.
Press SHIFT+ TEMP to choose thermocouple function.
3.
Press CONFIG, and then use
◁
and
▷
to locate “REAL”, then
press ENTER to
check the present temperature.
4.
Press ESC to reach the upper layer.
5.
Press
◁
and
▷
to locate “RJUNCTION”, then do the prcedure ENTER > REAL to
execute the function.
Figure 3-13
Simulated Temperature Setup
1.
Select a type and matched an adaptor correctly as shown in
Figure 3-14
.
2.
Press SHIFT+ TEMP to choose thermocouple function.
3.
Press CONFIG, and then use
◁
and
▷
to locate
“RJUNCTION” >
“SIMULATED”
.
4.
Use
◁
and
▷
to move through the digits and
△
and
▽
to increase or decrease the
numbers to a desired value.
5.
Press ENTER to execute the function.
