79
3.4.3 Reading Memory (Store & Recall)
DL-1060 has a memory capacity of 2000 readings. The readings are stored in
first-in-first-out order and the memory type is volatile, which means the stored
readings will be cleared when the multimeter is power-off. The reading memory
feature can be used for all measurement functions, math operations, trigger
operations and reading hold. The default number of readings to store is 100 and the
anunciator “MEM” will light up when STORE feature is
enabled.
How to use the reading memory
You can store the readings and access to the stored readings through either the front
panel operation or the remote interface operation.
※
Note: Each datum stored from DL-1060 to remote interface will be in a first in and
first out condition.
Front Panel Operation
Before using the reading memory feature, you need to select a measurement function
(or the math function) first and then select the trigger mode.
How to enable Reading Memory (to store readings)
Press STORE button, and the multimeter will start to store the readings produced until
the specified number of readings is reached.
How to set the number of readings to be stored
1.
Press SHIFT + CONFIG buttons as shown in
Figure 3-32
.
2.
Do the procedure “
TRIG SYS
” > “
STORE RDGS
”
> ENTER to set the number of
readings. Use
◁
and
▷
buttons to move between the digits and
▽
and
△
buttons to increase or decrease numbers as desired. When ready, press ENTER
button.
Figure 3-32
