200
-221 Settings conflict; burst count reduced
Example: The burst count is reduced to allow for the waveform
frequency if the burst period is at it’s maximum.
-221 Settings conflict; trigger delay reduced to fit entire burst
Example: The trigger delay is reduced to allow the current
period and burst count.
-221 Settings conflict;triggered burst not available for noise
Example: Triggered burst cannot be used with noise.
-221 Settings conflict;amplitude units changed to Vpp due to high-Z load
Example: If a high impedance load is used, dBm units cannot be
used. The units are automatically set to Vpp.
-221 Settings conflict;trigger output disabled by trigger external
Example: The trigger output terminal is disabled when an
external trigger source is selected.
-221 Settings conflict;trigger output connector used by FSK
Example: The trigger output terminal cannot be used in FSK
mode.
-221 Settings conflict;trigger output connector used by burst gate
Example: The trigger output terminal cannot be used in gated
burst mode.
-221 Settings conflict;trigger output connector used by trigger external
Example: The trigger output connector is disabled when the
trigger source is set to external.
-221 Settings conflict;frequency reduced for pulse function
Example: When the function is changed to pulse, the output
frequency is automatically reduced if over range.
-221 Settings conflict;frequency reduced for ramp function
Example: When the function is changed to ramp, the output
frequency is automatically reduced if over range.
-221 Settings conflict;frequency made compatible with burst mode
Example: When the function is changed to burst, the output
frequency is automatically adjusted if over range.
-221 Settings conflict;frequency made compatible with FM
Example: When the function is changed to FM, the frequency is
automatically adjusted to suit the FM settings.
-221 Settings conflict;burst turned off by selection of other mode or modulation
Example: Burst mode is disabled when sweep or a modulation
mode is enabled.
-221 Settings conflict;FSK turned off by selection of other mode or modulation
Example: FSK mode is disabled when burst, sweep or a
modulation mode is enabled.
-221 Settings conflict;FM turned off by selection of other mode or modulation
Example: FM mode is disabled when burst, sweep or a
modulation mode is enabled.
-221 Settings conflict;AM turned off by selection of other mode or modulation
Example: AM mode is disabled when burst, sweep or a
modulation mode is enabled.
Summary of Contents for FGX-2220
Page 1: ...B71 0406 01 INSTRUCTION MANUAL ARBITRARY FUNCTION GENERATOR FGX 2220...
Page 98: ...85...
Page 137: ...124...
Page 227: ...214 9 2 External Dimensions Figure...
