202
-221 Settings conflict;offset changed due to amplitude
Example: The offset is not a valid offset value, it is
automatically adjusted, considering the amplitude.
|offset|≤ max amplitude – Vpp/2
-221 Settings conflict;amplitude changed due to offset
Example: The amplitude is not a valid value, it is automatically
adjusted, considering the offset.
Vpp ≤ 2X (max amplitude -|offset|)
-221 Settings conflict;low level changed due to high level
Example: The low level value was set too high. The low level is
set 1 mV less than the high level.
-221 Settings conflict;high level changed due to low level
Example: The high level value was set too low. The high level is
set 1 mV greater than the low level.
-222 Data out of range;value clipped to upper limit
Example: The parameter was set out of range. The parameter is
automatically set to the maximum value allowed.
SOURce[1|2]:FREQuency 25.1MHz.
-222 Data out of range;value clipped to lower limit
Example: The parameter was set out of range. The parameter is
automatically set to the minimum value allowed.
SOURce[1|2]:FREQuency 0.1μHz.
-222 Data out of range;period; value clipped to ...
Example: If the period was set to a value out of range, it is
automatically set to an upper or lower limit.
-222 Data out of range;frequency; value clipped to ...
Example: If the frequency was set to a value out of range, it is
automatically set to an upper or lower limit.
-222 Data out of range;user frequency; value clipped to upper limit
Example: If the frequency is set to a value out of range for an
arbitrary waveform using, SOURce[1|2]: APPL: USER or
SOURce[1|2]: FUNC:USER, it is automatically set to the upper
limit.
-222 Data out of range;ramp frequency; value clipped to upper limit
Example: If the frequency is set to a value out of range for a
ramp waveform using, SOURce[1|2]: APPL: RAMP or
SOURce[1|2]:FUNC:RAMP, it is automatically set to the upper
limit.
-222 Data out of range;pulse frequency; value clipped to upper limit
Example: If the frequency is set to a value out of range for a
pulse
waveform
using,
SOURce[1|2]:
APPL:PULS
or
SOURce[1|2]:FUNC:PULS, it is automatically set to the upper
limit.
-222 Data out of range;burst period; value clipped to ...
Example: If the burst period was set to a value out of range, it is
automatically set to an upper or lower limit.
222 Data out of range;burst count; value clipped to ...
Example: If the burst count was set to a value out of range, it is
automatically set to an upper or lower limit.
Summary of Contents for FGX-2220
Page 1: ...B71 0406 01 INSTRUCTION MANUAL ARBITRARY FUNCTION GENERATOR FGX 2220...
Page 98: ...85...
Page 137: ...124...
Page 227: ...214 9 2 External Dimensions Figure...
