50
9-2. Connecting IF-41GU/IF-41USB
・
It is possible to control the PW-A power supply units using the IF-41GU through the GP-IB or USB.
(IF-41USB : USB only) It is necessary to set the PC addresses and system addresses in the local
bus master. Set the system addresses only in the slave units.
・
The PW-A series power supply units can only be connected and the PWR series cannot be
connected.
・
For the address setting procedures, see sections “9-3-2.” and “9-3-3.”.
・
Be sure to turn on the local bus master unit after turning all other slave units.
9-2-1. Remote control through GP-IB (IF-41GU only)
・
It is possible to connect a maximum of 14 local bus master units directly with a computer using
GP-IB cables. It is possible to connect a maximum of 31 slave units with each local bus master
unit connected directly with the computer using two twisted pair wires. Fig.25 shows the
connection diagram.
Fig.25 Remote Control through GP-IB using IF-41GU
