68
9-7-18. Storing set data
MW1
・
The MW1 command stores all storable settings in the EEPROM. It takes about 15 seconds
(approx 2 seconds for after Ver. 3.00 of the unit) to store data. Do not send any commands or
carry out any operations until PW-A unit send "MW1" message when store data is finished.
※
For the storable settings, see section "5-2-2. Initial setting when power is turned on" above.
9-7-19. Checking controlled unit
PW?
・
The PW? command checks the addresses of the slave units currently specified as the units to be
controlled.
・
This command is valid only when the IF-41GU/IF-41USB is used.
9-7-20. Checking connected slave unit
SLV?
・
The SLV? command checks the addresses of the slave units connected.
・
This command is valid only when the IF-41GU/IF-41USB is used.
9-7-21. Inquiry about optional board ID
＊
IDN
？
・
The
＊
IDN? command inquires about the ID of the optional board built in the local bus master.
・
This command is valid only when the IF-41GU/IF-41USB is used.
