Texmate, Inc. Tel. (760) 598-9899 • www.texmate.com
Mar-07-2016 DI-50AN6 320 DS (NZ303)_UL_March 2016
Page 12
Display Configuration
Once you have read the User manual and related supplements,
and installed and powered-up the meter, configure the display
to suit its designated application.
Display Brightness Mode
The
display brightness mode
is accessed when entering the
main programming mode. It allows you to adjust the brightness
of the display LEDs and setpoint annunciators without interfer-
ing with other configuration settings. It is always available, even
with the PROGRAM LOCK switch set to ON, or the external
LOCK pin connected to the COMMON pin, locking out the
programming modes.
The display brightness can be set between 0 and 7, with 0
being dull and 7 being bright. The default setting is 5.
Step 1
Step 2
Step 3
Operational Display
Example
Operational Display
Press
at same
time
Press
at same
time
Press
at same
time
Press
at same
time
CONFIGURING THE DISPLAY BRIGHTNESS PROCEDURE
Enter
Brightness Mode
Adjust brightness to 7
Save brightness setting.
Exit Brightness Mode.
Return to Operational
Display
OR
DISPLAY
BRIGHTNESS MODE
Example Procedure:
Configure the display brightness setting to 7 (bright).
Programming Tip
The
Display Brightness
setting procedure can
be performed at any time without interfering
with other configuration settings by entering the
main programming mode.
START HERE
Initial Setup Procedures
[bri] - Display Brightness
Initial Setup Procedures
Initial Setup Procedures continued
Programming Tip
Code Blanking and Macro ON/OFF set-
tings revert to the meter’s original configu-
ration settings when the meter is powered
off and on.
Step 7
Press the Prog. button.
continued from Step 4
Example
Macro
Step 6
Press the button to switch
the macro OFF
NOTE: Unless otherwise
requested, the factory
default setting is oFF
Step 5
Press the Prog. button.
Operational Display
Operational Display
Press
1
Press
1
Press
1