Mar-07-2016 DI-50AN6 320 DS (NZ303)_UL_March 2016
Texmate, Inc. Tel. (760) 598-9899 • www.texmate.com
Page 21
The following example procedure describes how to select the
last digit text character.
Example Procedure:
Configure Channel 1 with C as its last digit text character (for
°C) by setting Code 1 to [
X71
] to enter the Select Last Digit Text
Character Mode. See diagram opposite.
Enter
Brightness
Mode
Step 1
Step 2
Step 3
Operational Display
Press
2
Press
at same
time
Press
at same
time
Step 4
Step 6
Step 7
Step 8
Step 9
Step 5
Select [X0X] to leave
Code 1
Pass Brightness and
Calibration Modes
and enter Code 1
OR
Example
Press
1
Press
at same
time
Press
at same
time
OR
OR
Operational Display
X
X
X X
Press
1
0 Result
1 Channel 1
2 Channel 2
3 Channel 3
4 Channel 4
5 Default Display
6 Total 1
7 Total 2
CONFIGURE
LAST DIGIT
TEXT CHARACTER
From Step 6
Set Code 1 to [X71]:
1st Digit = X Note relevant
2nd Digit = 7 Selects text character mode
3rd Digit = 1 Selects channel 1
Exit
Code 2.
Return to
Operational Display
Select Text Character [C]
from the options listed in
the diagram above
CONFIGURING THE TEXT CHARACTER PROCEDURE
Save Last Digit Text
Character setting
To Step 7
Press
1
Configure Last Digit Text Character Procedure
START HERE
Initial Setup Procedures
[CodE_1] - Display Configuration continued
Select Last Digit Text Character
Press the
Up or Down
button 4
times as the
next 4 char-
acters are
blank.
Use the button to cycle through the
menu, and the button to cycle back.