Texmate, Inc. Tel. (760) 598-9899 • www.texmate.com
Mar-07-2016 DI-50AN6 320 DS (NZ303)_UL_March 2016
Page 22
Enter
Brightness
Mode
Step 1
Step 2
Step 3
Operational Display
Press
2
Press
at same
time
Press
at same
time
Step 4
Step 5
Pass Brightness and
Calibration Modes
and enter Code 1
OR
OR
Operational Display
XX
Press
1
CONFIGURE
SETPOINT
ANNUNCIATORS
CONFIGURE
UPDATE AT
SAMPLE RATE
Exit
Code 2.
Return to
Operational Display
Enter
Brightness
Mode
Step 1
Step 2
Step 3
Operational Display
Press
2
Press
at same
time
Press
at same
time
Step 4
Step 5
Pass Brightness and
Calibration Modes
and enter Code 1
OR
Operational Display
X X
Press
1
Exit
Code 2.
Return to
Operational Display
Press
1
UPDATE AT SAMPLE RATE PROCEDURE
Save setting and
enter Code 2
CONFIGURING THE SETPOINT ANNUNCIATORS PROCEDURE
Save setting and
enter Code 2
Set Code 1 to [1XX]:
1st Digit = 1 ON when SP OFF
2nd Digit = X Not relevant
3rd Digit = X Not relevant
Set Code 1 to [X2X]:
1st Digit = X Not relevant
2nd Digit = 2 Updates at controlled
output rate
3rd Digit = X Not relevant
The following example procedure describes how to configure
setpoint annunciators.
Example Procedure:
Configure the setpoint annunciators to come ON when the set-
points are OFF (not active) by setting Code 1 to [
1XX
].
Configure Setpoint Annunciators Procedure
The following example procedure describes how to configure
the display to update at the sample rate selected in Code 2.
Example Procedure:
Update the display at the sample rate selected in Code 2 by
setting Code 1 to [
X2X
].
Configure Update at Sample Rate Procedure
Programming Tip
The
Configuring
Setpoint Annunciators
and the
Update at
Sample Rate
proce-
dures can be com-
bined so that Code 1
could be set to [12X]
(for the above exam-
ples) in a single pro-
cedure.
START HERE
START HERE
Initial Setup Procedures
[CodE_1] - Display Configuration continued