Texmate, Inc. Tel. (760) 598-9899 • www.texmate.com
Mar-07-2016 DI-50AN6 320 DS (NZ303)_UL_March 2016
Page 8
The display showing 99999 represents
the
OPERATIONAL DISPLAY
. After the
meter has been powered up, the display
settles and indicates the calibrated input
signal. This is known as the operational
mode and is generally referred to as
the operational display throughout the
documentation.
P
are used throughout the range of Tiger 320 Series document dia-
grams to represent the buttons and indicators on the meter, and
the actions involved in programming the meter:
Text or numbers shown between square brackets
in a description or procedure indicate the pro-
gramming code name of the function or the value
displayed on the meter display.
Symbol
Explanation
This symbol represents the
UP
button.
Shown in a diagram, pressing the UP button is
always indicated by a
right hand
.
This symbol represents the
DOWN
button.
Shown in a diagram, pressing the DOWN but-
ton is always indicated by a
right hand
.
Where two right hands are shown on the same
diagram with the word OR between them, this
indicates that both the and
buttons can
be used to adjust the display: UP for increase,
DOWN for decrease.
This symbol represents the
PROGRAM
but-
ton. In a procedure, pressing the program
button is always indicated by a
left hand
.
A
number indicates how many times it must be
pressed and released, or for how long it must
be pressed before releasing.
[Span]
[10000]
When two displays are shown
together as black on grey, this
indicates that the display is
toggling (flashing) between the
name of the function and the
value or configuration setting.
Where a number is not defin-
able, the default setting [000]
is shown.
If an X appears in the description of a 3-digit
programming code or in a configuration
procedure, this means that any number
displayed in that digit is not relevant to the
function being explained, or more than one
choice can be made.
Where a left and right hand are shown on separate buttons
on the same diagram, this indicates that the buttons must be
pressed at the same time.
The only exception to this rule is when carrying out the
Model
and Software Code Version Check
.
Programming procedures are graphic based with little descrip-
tive text.
Each procedure shows a number of meter panel displays running
in procedural steps from the top to the bottom of the page.
If need be, the procedure may run into two columns with the left
column running down the page and continuing at the top of the
right-hand column. Each action performed by the user is shown
as a numbered step.
Each procedural step shows the meter display as it looks before
an action is performed. The hand or hands in the procedural step
indicate the action to be performed and also how many times, or
for how long, the button is to be pressed.
For example, the diagram below shows the meter in the operation-
al display. With a left hand pressing the
P
button and a right hand
pressing the button, the user is entering the
main program-
ming mode
. This is indicated by the next diagram displaying [bri]
and [5]. This is the display brightness mode and is the first sub-
menu of the main programming mode.
The meter uses a set of intuitive
software codes to allow maximum
user flexibility while maintaining
an easy programming process.
To configure the meter’s program-
ming codes, the meter uses the
three right-hand side display dig-
its. These are known as the 1st,
2nd, and 3rd digits and can be
seen in the diagram opposite. To
explain software programming pro-
cedures, diagrams are used to
visually describe the programming
steps. The following conventions
First
Digit
Second
Digit
Third
Digit
Press
2
Press
4 secs
Step 1
Operational Display
Press
at same
time
Press
at same
time
Step 2
Press
2
OR
All programming modes are entered from this level
.
Front Panel Push Button Configuration and Setup for Programming Conventions