Texmate Tiger 320 DI-60E Manual Download

Page: 36 / 44

Texmate, Inc. Tel. (760) 598-9899 • www.texmate.com

Page 36

Mar-14-2016 DI-60 320 DS (NZ301)_UL_March 2016

Registers That Can Be Selected By Front Panel Push Button Programming

A Tiger 320 Series meter has 6,144 registers which are
provided for use by the operating system and the powerful
Custom Macro Programming system.

40 Manually Selectable Registers

Using the front panel buttons, there are 40 registers that

may be selected for use within the following functions:

• [

CodE_1] - Display Configuration [X50]

. Selection of a

•

Setpoint Control Settings [X1X]

. Selection of a register

as the data source for a setpoint. (See Page 34)

•

Setpoint Control Settings [XX7]

. Selection of a desti-

nation register that is to be reset by a setpoint with the
contents of a selected source register. (See Page 35)

•

Setpoint Control Settings [XX7]

. Select which register’s

contents are to be copied into the destination register by
a setpoint. (See Page 35)

The 40 registers that can be selected as a data source, a
reset source or a reset destination for the functions above
are shown in the table on the right.

The table shows, in seven columns, the functions where
these registers can be used.
Where a register is more likely to be used in a particular
function, a closed circle

●

is shown in the column. For those

functions where a register is less likely to be used, an open
circle

is s hown.

No register number is shown for the first 11 functions,
because these 11 functions are identified in the display
menu for direct selection by their code names.
When cycling through the Registers Menu and then
Registers 1 to 244, the numerical Register Set will incre-
ment through each decade in turn, from 1 to 0, while the
button is held down. When [200] is reached, [oFF] or [tArE]
will be displayed. To select a specific number set, the button
should be released and pressed again each time the left
most decade displays the desired number for that decade.
To quickly exit the numerical 1 to 244 Register Set, hold the

button down while cycling through the decades, and
release it when [oFF] or [tArE] appears.

Registers that Should Not be Used

The following registers are contained within the selectable

1 to 244 Register Set, but they should not be selected

because they are either reserved for future use, or for use

by the operating system only:

15, 38, 47-48, 52-53, 61-64, 123-128, 140-141, 234-244

Any selection of these Registers may cause a malfunction.

Resetting and Incrementing Using Setpoints

Setpoints may be used to reset and/or increment registers. In
the example shown below, 2 liter soft drink bottles are being
filled and packed 12 to a case. Using the setpoint reset and
increment feature, the number of bottles and the total number
of filled cases is easily calculated and displayed. Totalizer 1
counts from 0 to 2, resets, and repeats. CH 2 counts from 0 to
12, resets, and repeats.

USING SETPOINTS TO INCREMENT AND RESET REGISTERS

Data

Source

for

Analog

Outputs

1 & 2

Data

Source

for

Setpoints

Reset