STEP 7 -
Drape the rainfly over tent
with the awning over the front door.
Secure by attaching hook into tabs on
skin as shown above.
STEP 9 -
This is what your tent should
like with the rainfly on.
STEP 8 - Attach velcro to poles to
secure rainfly.
STEP 13 - Insert the pin of the assem-
bled awning pole into the grommet of
the awning as shown.
STEP 14 - Wrap a section of guy rope
around the pin of the pole.
STEP 15 - Stake down the other end
with the loop.
STEP 10 - Assemble the front awning
poles. Use the short series of poles in
the order shown above.
STEP 11 -
The awning will not stand up
by itself until it is guy roped. First make
a small loop and tie a knot.
STEP 12 - At the other end of the guy
rope,
insert the guy rope through the
hole in the clew and tie a knot.
D
H
H
F
STEP 16 - Adjust the tension in the guy
rope by hooking the clew to the guy
rope.
STEP 17 - Repeat steps 11 through 16
for the other awning pole. This is what
your tent should look like.
STEP 18 - Before attaching tent to SUV,
loosen and spread out attached web
straps.
STEP 19 - Slowly back up SUV with
rear door open as close to the tent as
possible. Wrap tent fabric around SUV
body as shown above. This step is
easier with two people.
STEP 20 - Wrap tent fabric around
bumper to secure.
STEP 21 - Locate the web straps with
buckels under the rear of the SUV
