OPERATION AND SERVICE INFORMATION
Page 16
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Dangers and Warnings
Changing the Oil
Tool List
Qty. Required
Socket, 3/8" drive ........................................................ 1
Ratchet, 3/8" drive ....................................................... 1
Extension, 3/8" drive, 8" .............................................. 1
Oil drain pan ................................................................ 1
Wrench, 3/4" ................................................................ 1
For maximum performance and longevity, the engine oil
should be replaced after the first 8 hours of operation.
After the initial oil change, it should be changed every
125 hours of operation or semi-annually, whichever
comes first.
The selection of oil is dependent upon the service that
the vehicle will perform. Most vehicles require 10W-30
oil, whereas vehicles used at capacity or near capacity
load applications will utilize 10W-40 oil after a break-in
period of 100 hours
Fig. 16 Oil Viscosity Chart
If vehicle is to be stored over winter months, it can be stored
with old oil left in engine. The oil should be changed as part of
spring maintenance. This will remove any moisture that has
accumulated during storage.
Be aware that engine fluids may be hot and
contact to the skin may cause severe burns.
Wear rubber gloves to protect skin from expo-
sure to the old oil and degreaser.
The oil should be changed with engine warm. Park vehicle on a
level surface, engage parking brake and remove key. Place a
drain pan under engine. Wipe top of the engine clean with a
cloth (Ref Fig. 17 on page - 16). Remove the oil fill cap.
Fig. 17 Cleaning Top of Engine
Clean the area around filter. Using a filter wrench, strap
wrench or other suitable wrench, remove the filter (B)
from the engine and allow the oil to drain. The ‘O’ rings
may remain on engine (A) or filter (B) (Ref Fig. 18 on
page - 16)
Fig. 18 Remove Oil Filter
Inspect the filter. Make sure the ‘O’ ring is not left on the
engine surface.
-20
0
20
40
60
80
100
-30
-20
-10
0
10
20
30
40
C
F
0
0
10W-30
10W-30
10W-40
10W-40
HEAVY DUTY WORK
LIGHT DUTY WORK
(AIR TEMPERATURE)
10W-30
10W-30
Ref Ovc 1
NOTICE
Oil Fill Cap
Summary of Contents for 614212 2010
