9
DRIFTLESS
SPRAYER
Electrical Hookup
1.
Route electrical harness along power unit frame. Avoid all pivot points and moving parts to avoid
pinching or wearing into cable.
2.
Plug cable into auxiliary 12V power outlet on power unit.
3.
Tie cable securely to power unit.
4.
Clean terminals of battery to ensure good connections.
Last Check
1.
Double check all fasteners, nuts and bolts adjusted during installation for tightness.
2.
Grease all grease nipples. There are two nipples at each wing pivot, one nipple for the Center Castor
Frame pivot and one nipple for each castor wheel pivot.
3.
Operate the front mount sprayer through its entire float range. Check for interference between the
frame, fenders, floor boards and attachments. Check also for pinching of hoses and electrical power
wire for pump.
4.
Place water in solution tank. Operate pump and spray through each boom section. Check all
plumbing for any possible leaks.
5.
Operate sprayer over concrete pad. Examine spray pattern on concrete to ensure all spray tips are
operating.
ASSEMBLY
Summary of Contents for 73-70675
