6
DISC
EDGER
OPERATION
OPERATING INSTRUCTIONS
1.
Refer to setting diagrams for proper settings for the type of edging required.
2.
To set wheel:
There are 2 holes to allow 90 degree rotation for the “FRONT” and “DOWN” settings.
3.
To set angle of disc:
Loosen 2 bolts and move in slot to desired setting. Tighten bolts.
4.
To set “lead” of forward edge of disc:
Rotate disc tube by removing bolt at tube adaptor and rotate to the next hole.
5.
To set disc “OUT”:
Remove pin and slide disc tube out to the next hole.
6.
To operate edger:
Apply down pressure sufficiently to raise the front wheels of the tractor off the ground. This applies the
weight of the tractor to the edger and enables you to steer.
7.
OPERATE WITH CAUTION!
