23
OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
High Pedal Disable Feature
High pedal disable prevents undesired acceleration if the direction selector lever is changed, or the key is turned on
while the accelerator is depressed.
Diagnostic Mode Feature
Diagnostic mode eases troubleshooting.
In the unlikely event of certain electrical system failures, the Diagnostic Mode feature (PDS controller on 48V Vehicle)
will default to a mode that will permit the vehicle to operate, but at a very reduced speed.
This feature allows the vehicle to be driven back to its storage facility where the problem can be diagnosed.
The controller can be put in diagnostic mode by the technician and the controller will report the failure mode.
STARTING AND DRIVING
To reduce the possibility of severe injury or death resulting from loss of vehicle control, consider
the grade of the terrain the vehicle is on and set vehicle’s park brake accordingly before switch-
ing the Run - Tow/Maintenance/Storage switch to the ‘Tow/Maintenance/Storage’ position. When
in the ‘Tow/Maintenance/Storage’ position, the Anti-Roll Back and Walk-Away safety features of
the system no longer function.
Before attempting to tow vehicle, move the Run-Tow/Maintenance/Storage switch to the ‘Tow/Maintenance/
Storage’ position. Failure to do so will damage the controller or motor.
Before disconnecting or connecting a battery, or any other wiring, move the Run-Tow/Maintenance/Storage
switch to the ‘Tow/Maintenance/Storage’ position.
After connecting a battery, or any other wiring, wait a minimum of 30 seconds before moving the Run-Tow/
Maintenance/Storage switch to the ‘Run’ position.
The Run - Tow/Maintenance/Storage switch should always be returned to the ’Tow/Maintenance/Storage’ position
after moving a stalled vehicle. If the switch is left in the ’RUN’ position for an extended period of time, it will drain the
batteries.
With the switch in ‘TOW/MAINTENANCE/STORAGE’ position:
•
the controller is deactivated
•
the electronic braking system is deactivated which allows the vehicle to be towed or roll freely
•
the warning beeper is deactivated
With the switch in ‘RUN’ position:
•
the controller is activated
•
the electronic braking system and warning beeper features are activated
To reduce the possibility of roll-back which could result in severe injury or vehicle damage, do
not release the service brake until motor has started.
All vehicles are equipped with an
interlock system
that disables the controller and prevents the vehicle from being oper-
ated or towed while the charger is connected. Remove the charger plug from the vehicle receptacle and properly store
the cable prior to moving the vehicle.
NOTICE
Summary of Contents for E-Z-GO Cushman TITAN 36V HD
Page 1: ...Owner s Guide Titan LD HD Electric 635592 B Issued NOVEMBER 2013 Revised JULY 2018...
Page 57: ......
Page 58: ......
