ES32 Battery-powered Cable Cutter
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
8
Troubleshooting
Before You Begin
1. Make sure that the battery is charged. Recheck the battery after several minutes to make sure the battery is
holding its charge.
2. Use a
nonflammable
contact cleaner or pencil eraser to clean the electrical contacts on the battery and
cutting tool.
3. Reinstall the battery and check the tool again.
Problem
Probable Cause
Probable Remedy
Tool is inoperative.
Dirt, contaminants, etc., in ram area
of tool.
Clean tool.
Cutting tool battery contacts
damaged.
Reform contacts.
Tool components worn or damaged.
Return tool to a Greenlee Authorized
Service Center.
Blades stop during operation.
Oil level is low.
Return tool to a Greenlee Authorized
Service Center.
Air in hydraulic system.
Pull trigger and hold retract button
simultaneously. Hold for approximately
10 seconds.
LED glows for 20 seconds.
Battery charge low.
Charge or replace battery.
Tool loses oil.
Damaged internal seal.
Return tool to a Greenlee Authorized
Service Center.
