Greenlee / A Textron Company
13
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
12-ton, Single-acting, Die-type Crimping Tools
Assembly—RK1240K(C) [refer to Illustration—RK1240K(C)]
1.
Install the Spring Plunger (38) and Socket Head
Cap Screw (2) to the C-head (1).
2.
Inspect the external surface of the ram and the
inside surface of the cylinder for nicks, gouges or
other imperfections. Replace the ram or cylinder if
necessary.
3.
Slide the Wiper (17) onto the Ram (15) as far as
they will go. Place the U-cup Seal (21) on the Ram.
4.
Assemble the Extension Spring (19) to the two
Spring Retainers (18,20).
5.
Thread the Spring Retainer (20) into the base of the
Cylinder (23), use a 5mm Allen wrench to tighten
the spring retainer.
6.
Lubricate the O-ring (22), Backup Ring (21) and
threads on the Cylinder and Ram.
7.
Slide the ram assembly into the cylinder far enough
for full O-ring and Backup Ring engagement.
8.
Slip the cylinder / ram assembly into the base of the
C-head and start threading them together. Continue
to thread the cylinder into the C-head until the
cylinder hits the C-head.
9.
Install the three Spring Plungers (5).
10. The C-head is locked in place with Set Screw (7).
11. Install Nylon Washer (14) and 8mm Screw (13)
through the ram, and tighten securely.
12. Use Pipe Sealer and assemble the 3/8" NPT Pipe
(24) to the 3/8 Coupler (25). Assemble to the
cylinder.
electronic components distributor