Greenlee / A Textron Company
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
12-ton, Single-acting, Die-type Crimping Tools
IMPORTANT SAFETY INSTRUCTIONS
• Do not operate crimping tool without dies in place.
Damage to the ram or crimping tool head may
result.
• Do not perform any service or maintenance other
than as described in this manual. Injury or damage
to the tool may result.
Follow the operating instructions and safety
information supplied with the hydraulic power
source.
Inspect tool and dies before use. Replace any
worn or damaged parts. A damaged or improperly
assembled tool could break and strike nearby
personnel with sufficient force to cause severe
injury or death.
Use proper die, connector, and wire combinations.
Mismatched components can result in an incom-
plete crimp. Failure to complete a crimp could result
in severe injury, death, or fire if a connection
separates or if it has high electrical resistance.
Pinch points:
Keep hands away from closing dies.
Failure to observe this warning could
result in severe injury or death.
Wear eye protection when using
this tool.
Failure to wear eye protection
could result in serious eye injury
from flying debris or hydraulic oil.
Skin injection hazard:
• Do not use fingers or hands to
check for leaks.
• Depressurize hydraulic system
before servicing.
High pressure oil easily punctures
skin causing serious injury, gangrene
or death. If injured seek medical help
immediately to remove oil.
Electrical shock hazard:
This tool is not insulated. When
using this unit near energized
electrical lines, use only certified
non-conductive hoses and proper
personal protective equipment.
Failure to observe this warning could
result in severe injury or death.
electronic components distributor