HE.8217_C © 10/2011
4
SDG45 / SDG45C
GB
Instruction Manual
4.3. Service and maintenance instruction
The hydraulic tool must be cleaned and dried after each use. The cutting head must be examined for possible dama-
ges. The hydraulic hose and the armature must be checked for damage and leakage.
The unit must be sent to an authorized service center (ASC) after reaching 30.000 cycles or at the latest after one
year. During this service worn out parts will be exchanged, safety relevant components checked and possibly re-
placed pre cautiously. This provision serves your safety and avoids failures through fatigue.
Attention
Have the power tool repaired by a qualifi ed expert or by a Klauke Service Center (ASC).
4.4 Reference as to which spare parts can be exchanged by the customers
During the warranty periot do not attempt to repair the tool yourself, and do not remove any parts such as screws
and other components.
5. Troubleshooting
The tool loses oil. Return the tool to the manufacturer. Do not open the tool.
6. Technical Data
Cutting range:
max. 45 mm Ø
Cutting force:
60 kN (at 700 bar pressure)
Weight:
approx. 3,8 kg
Length:
approx. 340 mm
max. operating pressure: 700 bar
Note
Additional copies of this instruction manual are available upon request. The part # is HE.8217.
The Instruction Manual can also be downloaded from our Homepage www.klauke.textron.com.
