17
EC
Hydro
Midsize
HEIGHT OF CUT
3. CUTTERDECK POSITION
The cutterdeck has FIVE positions relative to the en-
gine deck. To change height of cut start on one side
of cutterdeck.
1. Place support blocks of the appropriate thickness
under both rear outside edges of the cutterdeck
at
B
. See Support Block Chart below.
2. Remove guide pin
A
if installed.
3. Remove the top (2) M12-1.75 bolts.
4. Loosen the lower (2) M12-1.75 bolts
D
enough to
allow the deck to lower onto the support blocks,
or if the deck is being raised, allow the front of
the deck to lower onto the caster wheels.
5. Reinstall top (2) M12-1.75 bolts and tighten all (4)
bolts
C
and
D
.
6. Reinstall belt cover.
CUTTING HEIGHT
HOLE POSITION ON EN-
GINE DECK*
BLOCK HEIGHT AT REAR
OF DECK (B)
1.375" - 1.625"
(34.9mm-41.3mm)
5
1.25" (31.7mm)
1.875"-2.375"
(47.6mm-60.3mm)
4
2.00" (50.8mm)
2.625"-3.125"
(66.7mm-79.4mm)
3
2.75" (69.8mm)
3.375"-3.875"
(85.7mm-98.4mm)
2
3.50" (88.9mm)
4.125"-4.625"
(104.8mm-117.5mm)
1
4.25" (107.9mm)
*Position 1 is the highest hole on the engine deck.
