SB750-55-10
Page 4
Revision 4 - April 7, 2016
Citation
SERVICE BULLETIN
SB750-55-10
H.
(Refer to Figure 1, Detail B.) Attach the two 6738022-7 HSTA Controller Assemblies to the
6738021-9 HSTA Filter Assembly with four MS27039-1-16 Screws into the top and bottom holes of
the 6738022-7 HSTA Controller Assemblies as shown.
I.
(Refer to Figure 1, Detail B.) Install the four MS27039-1-20 Screws thru the aft side of the two
6738022-7 HSTA Controller Assemblies.
J.
Torque the eight MS27039-1-16 Screws and four MS27039-1-20 Screws in the order as shown
below. (Refer to the Cessna Model 750 Maintenance Manual, Chapter 20, Torque Data -
Maintenance Practices.)