B
BODY
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
27
Repair and Service Manual
668061
Cargo Tray Removal
Tool List
Qty.
Ratchet ........................................................................ 1
Torx Bit, T30 ................................................................ 1
Screwdriver, Flat Tip.................................................... 1
Torque Wrench, in. lbs................................................. 1
1.
Remove the plastic rivets (11) that secure the edges
of the cargo tray (3) to the side panels (See Fig. 13).
2.
Remove the screws (10) that secure the cargo tray
to frame and the cab closeout panel (2). Lift the
cargo tray out of the vehicle.
3.
Installation is the reverse order of removal.
NOTICE: Make sure that the heat shields are attached
to the cargo tray components before installation.
4.
Tighten the hardware to the torque specified below:
Rear Closeout Panel Removal
Tool List
Qty.
Ratchet ........................................................................ 1
Torx Bit, T30 ................................................................ 1
Screwdriver, Flat Tip.................................................... 1
Torque Wrench, in. lbs................................................. 1
1.
Remove the screws (4) that secure the top edges of
the rear closeout panel (2) to the ROPS tubes (See
2.
Remove the plastic rivets (11) that secure the panel
(2) to the bracket (1). Remove the rear closeout
panel.
3.
Installation is the reverse order of removal.
4.
Tighten the hardware to the torque specified below:
Front Closeout Panel Removal
Tool List
Qty.
Ratchet ........................................................................ 1
Torx Bit, T30 ................................................................ 1
1.
Remove the air filter and CVT air intake hoses from
the front panel. See the CVT and AIR INTAKE sec-
tions.
2.
Disconnect the electric control unit. See the ELEC-
TRICAL SYSTEM section.
3.
Remove the plastic rivets (11) that secure the front
closeout panel (8) to the seat frame and B-pillar
4.
Remove the plastic rivets (11) that secure the top of
the front closeout panel (8) to the B-pillar crossmem-
ber.
5.
Remove the front closeout panel.
6.
Installation is the reverse order of removal.
Extended Cab Door Removal
Tool List
Qty.
Ratchet ........................................................................1
Torx Bit, T30.................................................................1
Screwdriver, Flat Tip ....................................................1
Torque Wrench, in. lbs. ................................................1
1.
Remove hinge covers (30) from the hinges (37) (See
2.
Remove the screws (40) that secure the hinges (37)
to the door panels (33). Remove the door panel (33)
from the vehicle.
3.
Installation is the reverse order of removal.
4.
Tighten the hardware to the torque specified below:
Fig. 14 Extended Cab Doors
Item
Torque Specification
10
44 - 72 in. lbs. (5 - 8 Nm)
Item
Torque Specification
4
44 - 72 in. lbs. (5 - 8 Nm)
Item
Torque Specification
40
13 - 20 in. lbs. (1.5 - 2.3 Nm)
Front of Vehicle
40
37
33
Side Panel
30
Summary of Contents for Stampede 900 2017
