B
74
Repair and Service Manual
FRONT CV SHAFT, SUSPENSION AND STEERING
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
668061
Fig. 18 Upper Control Arm Removal
7.
Remove the nuts (28) and bolts (27) that secure
each side of the upper control arm to the vehicle
frame (Ref. Fig. 18).
8.
Remove the upper control arm from the vehicle.
Installation of upper control arm assembly is the reverse
of removal.
NOTICE: Make sure bushings (21) and spacers (22)
are in place in the upper control arm before installa-
9.
Tighten the hardware to the torque values specified
below:
Stabilizer Bar Removal
Tool List
Qty.
Ratchet ........................................................................ 1
Socket, 18mm..............................................................1
Socket, 17mm..............................................................1
Wrench, 18mm ............................................................1
Wrench, 17mm ............................................................1
Torque Wrench, ft. lbs..................................................1
1.
Remove bolts (38), washers (37) and nuts (33)
securing the stabilizer bar ends to the stabilizer bar
linkages (Ref. Fig. 1).
2.
Remove bolts (32) and nuts (28) that secure the sta-
bilizer bar bracket to the vehicle frame.
3.
Remove the stabilizer bar.
4.
Installation is the reverse of removal.
5.
Tighten the hardware to the torque values specified
below:
FRONT DIFFERENTIAL
Fig. 19 Fill and Drain Plugs
Check and replace the front differential oil at the intervals
Front Differential Oil Check
Tool List
Qty.
Rag ...........................................................................AR
Drain Pan .....................................................................1
Ratchet.........................................................................1
Ratchet Extension........................................................1
Hex Bit, 8mm ...............................................................1
Item
Torque Specification
27, 28
70 - 77 ft. lbs. (95 - 105 Nm)
33, 46
40 - 44 ft. lbs. (54 - 60 Nm)
27
28
Item
Torque Specification
38, 33
70 - 77 ft. lbs. (95 - 105 Nm)
32, 28
30 - 33 ft. lbs. (40 - 45 Nm)
Drain Plug
(view of underside of
front differential)
Fill Plug
Summary of Contents for Stampede 900 2017
