B
78
Repair and Service Manual
FRONT CV SHAFT, SUSPENSION AND STEERING
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
668061
Steering Wheel Replacement
Tool List
Qty.
Paint Marker ................................................................1
Socket, 24mm..............................................................1
Ratchet ........................................................................ 1
Hammer....................................................................... 1
Ball Peen Hammer ......................................................1
Torque Wrench, ft. lbs..................................................1
Anti-Seize Compound...............................................AR
NOTICE: To maintain the correct orientation when
replacing the steering wheel, turn the wheels
straight ahead.
Mark the orientation of the steering wheel to the
steering shaft for proper alignment during assem-
bly.
To prevent damage to the steering wheel cover, per-
form the following removal procedure. Do not use a
screwdriver to pry the cover off.
1.
Remove the steering wheel cover (5) by pulling it
straight up (See Fig. 21) (See Fig. 22).
Fig. 23 Steering Wheel Nut Removal
2.
Remove the lock nut (6) securing the steering wheel
to the steering shaft (Ref. Fig. 23).
NOTICE: To prevent damage to the steering shaft,
do not use excessive force to strike the steering
shaft with the ball peen hammer.
3.
With the aid of an assistant, place a ball peen ham-
mer against the steering shaft end (24) and strike the
hammer with another hammer while applying upward
pressure to the steering wheel (Ref. Fig. 24) (See
4.
Remove the steering wheel (Ref. Fig. 25).
Fig. 24 Steering Wheel Separation
Fig. 25 Steering Wheel Removal
5.
Before installing the steering wheel, lightly coat the
splines of the steering shaft with (24) anti-seize com-
6.
With the wheels in the straight ahead position, align
the steering wheel on the steering shaft (24) and
slide the steering wheel onto the shaft.
7.
Tighten the lock nut to the torque value specified
below:
8.
Install the steering wheel cover.
6
Item
Torque Specification
6
20 - 22 ft. lbs. (27 - 30 Nm)
24
Summary of Contents for Stampede 900 2017
