B
82
Repair and Service Manual
FRONT CV SHAFT, SUSPENSION AND STEERING
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
668061
NOTICE: Wheel alignment is required after installa-
tion. See Wheel Alignment.
4.
Tighten the hardware to the torque values specified
below:
MAINTENANCE
Consistent routine maintenance of the front suspension
and steering consists of routine lubrication. See
recommended lubricants.
Examination of the tires will provide indications that an
alignment is required.
NOTICE: Some maintenance items must be serviced
more frequently on vehicles used under severe driv-
ing conditions.
Wheel Alignment
Tool List
Qty.
Floor Jack ....................................................................1
Jack Stands .................................................................2
Wheel Chocks .............................................................4
Measuring Tape ...........................................................1
Wrench, 17mm ............................................................2
1.
To center the steering unit in the middle of its travel,
turn the steering wheel to the left until the it contacts
the steering stop.
2.
Rotate the wheel to the right while counting the num-
ber of turns required to contact the right steering
stop. Divide the number of turns by two. This indi-
cates the number of steering wheel turns required to
achieve center.
Roll the vehicle forward 10 feet (3 meters). Measure the
center tread distance at the front of the tires (Ref. Fig.
33). Measure as close to parallel with the front lower
frame of the vehicle as possible.
Fig. 33 Wheel Alignment Front of Front Tires
3.
Similarly, measure the center tread distance on the
rear of the front tires. The correct measurement is 0
to 1/8 inch (0 - 3.2mm) toe in.
NOTICE: Counting threads or measuring thread dis-
tance are both acceptable methods to equalize tie
rod length.
4.
To adjust the wheel alignment, loosen the tie rod jam
nut (42), holding the hex form on the tie rod (44)
(Ref. Fig. 34).
Fig. 34 Wheel Alignment
5.
If the tie rods or ends have been replaced, adjust
both rods the same distance prior to reinstalling them
on the vehicle. After adjustment, tighten the jam nut
(42) to the torque value specified below:
Item
Torque Specification
2
17 - 20 ft. lbs. (23 - 27 Nm)
Item
Torque Specification
42
20 - 25 ft. lbs. (27 - 34 Nm)
Summary of Contents for Stampede 900 2017
