B
BODY
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
25
Repair and Service Manual
668061
Seat Bottom Removal
1.
The seat bottom (1) is removed by grasping the front
edge of the seat bottom and pulling up and out of the
2.
To install the seat bottom, align the alignment pins
on the bottom, front of the seat bottom with the rub-
ber grommets on the seat frame. Push the seat bot-
tom down into place.
Seat Back Removal
Tool List
Qty.
Ratchet ........................................................................ 1
Torx Bit, T45 ................................................................ 1
Torque Wrench, in. lbs................................................. 1
1.
Remove the four bolts (21) that secure the seat back
(14) to the seat back supports (12) (See Fig. 12).
2.
Remove the seat back from the vehicle.
3.
Installation is the reverse of removal.
4.
Tighten the hardware to the torque specified below:
Seat Closeout Removal
Tool List
Qty.
Ratchet ........................................................................ 1
Torx Bit, T30 ................................................................ 1
Screwdriver, Flat Tip.................................................... 1
1.
Remove the four bolts (9) that secure the bottom of
the seat closeout (6) to the seat frame (See Fig. 12).
2.
Remove the four plastic rivets (10) that secure the
top of the seat closeout (6) to the seat frame.
3.
Remove the seat closeout from the vehicle.
4.
Installation is the reverse of removal.
Item
Torque Specification
21
15 - 20 in. lbs. (20 - 27 Nm)
Summary of Contents for Stampede 900 2017
