7.
WEATHER REPORT short cut button
Press this key to go straight into the weather report screen
8.
ENTER button
Press this ENTER button to confirm
9.
Screen ON-OFF button
Press to turn ON/OFF the display screen
B3. OUTDOOR REMOTE THERMO-HYGRO SENSOR
1.
LED indicator
Flashes when remote unit transmits a reading.
2.3.Temperature & Humidity display
LCD Display for temperature and humidity readouts.
4.
Channel number
Indicates the adjusted channel number of the remote sensor.
5.
Battery Compartment
The remote sensor has 3 function buttons inside the battery compartment (5):
6.
CH button
After the battery installation, the LED blinks slowly every 1.5 seconds to indicate it is now under
channel setting mode and is set to channel 1 by default.
If the user presses no key within 10 seconds, the unit will auto-exit the channel setting.
If the user presses [CH] button once during the channel setting, the LED will blink twice every 1.6
seconds to indicate the unit is set to channel 2.
If the user presses [CH] button again, the channel number will be advanced to channel 3 and the
LED will blink 3 times and so on.
The maximum channel number is “5” and the unit will be scrolled back to channel ‘1’ at the 5th press
of the [CH] button.
7.
°C/°F Button
Press to toggle unit °C or °F
8.
RESET Button
Press to reset the transmitter to factory setting.
C. SETTING PROCEDURE TO LINK UP WITH THE FRAME UNIT
The remote sensor is designed for easy set up with no wire installation. The following steps are
required to be done in conjunction with the procedure descript in section 6.10 on “How to install
remote sensor”
1.
Remove the bracket stand.
2.
Unlock two latches in the bottom to release the semi-transparent jacket.
3.
Slide down the battery door at the rear side.
4.
Insert x2 AAA batteries according to polarity marking on the battery compartment.
5.
The LED blinks slowly every 1.5 seconds to indicate it is now under channel setting mode. It is set
to channel 1 by default, the user can change the channel by pressing [CH] button (see CH button).
6.
The temperature and humidity of the sensor will appear on the selected channel of the frame unit
if it is linked up with the receiving unit successfully.
7.
Close the battery door and use two latches in the bottom to lock it with the semi-transparent jacket.
Follow the same procedure (1 to 7) to register other remote sensors.
NOTE: Users purchasing more than one remote sensor must set the sensors to different
channels in the start up to avoid conflicts.
