25
24
MONDO –
Wireless weather station
Therefore, please note the following steps:
• The recommended distance to any interfering sources like computer screens or TV sets is at least 1.5 - 2 meters.
• Within concrete walls (reinforced with steel) such as basements, the received signal is naturally weakened. In extreme cases,
please place the unit close to a window to improve reception.
• During night-time, the atmospheric interference is usually less severe and reception is possible in most cases. A single daily
reception is adequate to keep the accuracy deviation under 1 second.
7. Backlight
7.1 Battery operation
• Press any button to temporarily activate the backlight.
• You can select between two levels of brightness with the
SNOOZE/LIGHT
button (HI/LO).
• Press the
SNOOZE/LIGHT
button to activate the backlight briefly. The default setting is HI.
• Press the
SNOOZE/LIGHT
button once again to dim the backlight.
7.2. Adapter operation (optional)
•
Attention:
Continuous illuminated backlight only works when using the power adapter.
• Press
SNOOZE/LIGHT
button once to dim the backlight.
• Press
SNOOZE/LIGHT
button once more to turn off the backlight.
• The sequence is shown as follow: HI – LOW - OFF.
8. Operation
• The device will automatically quit the setting mode if no button is pressed for a few seconds.
• Press and hold the
UP
or
DOWN
button in setting mode for fast mode.
8.1 Manual settings
• Press and hold the
MODE
button in normal mode for three seconds to enter the setting mode.
• The time zone (00 = default) will be flashing on the display.
• Press the
UP
or
DOWN
button to make the time zone correction (+12/-12).
• The time zone correction is needed for countries where the DCF signal can be received but the time zone is different from
the DCF time (e.g. +1=one hour plus).
MONDO –
Wireless weather station
• Press the
MODE
button to make the settings in the following sequence: Hour, minutes, year, month, day and the language
of the day of the week. Press
UP
or
DOWN
button to adjust it.
• Confirm the setting with the
MODE
button.
• The manually set time is overwritten once the DCF time signal is successfully received.
8.1.1 Day-of-week language setting
• In the setting mode you can choose the day-of-the-week language.
• Press the
UP
or
DOWN
button.
• In the display appears: German - GER (default), French - FRE, Italian - ITA, Dutch - DUT, Spanish - SPA, Danish - DAN and
English - ENG.
• Confirm the setting with the
MODE
button.
8.2 24- or 12-hour system setting
•
In normal mode you can choose between the 12 HR or 24 HR system.
• Press the
DOWN
button.
• In the 12-HR system PM (after noon) appears on the display.
8.3 Temperature unit setting
• In the normal mode you can change between °C (Celsius) or °F (Fahrenheit) as temperature unit.
• Press the
UP
button
9. Alarm clock function
• Press the
MODE
button in normal mode.
• AL1 and 6:00 (default) or the last adjusted alarm time appear on the display.
• Press and hold the
MODE
button for 3 seconds.
• The hour digit starts to flash.
• Press the
UP
or
DOWN
button to adjust the hours.
• Press the
MODE
button again and you can adjust the minutes with the
UP
or
DOWN
button.
• Press the
MODE
button to return to normal mode.
• Press the
MODE
button twice in normal mode.
• AL2 and 0:00 (default) or the last adjusted alarm time appear on the display.
TFA_No. 35.1151_Anleitung 16.08.2018 15:06 Uhr Seite 13