23
22
AIRCO
2
NTROL COACH
– CO
2
Monitor
AIRCO
2
NTROL COACH
– CO
2
Monitor
7 = GREEN
• Confirm with the
MODE
button.
• “AL” appears and the default setting is 1400 ppm.
• Use the
+
button to set the desired alarm limit (400 to 3000 ppm) in increments of 100 for the “AL” mode
• Confirm with the
MODE
button.
• The time appears on the display. The hour digits flash.
• Press the
+
button to adjust the hours.
• Press the
MODE
button again and set minutes in the same way.
• Confirm with the
MODE
button.
• “ECO L” appears and the default setting is OFF. If the ECO LIGHT function is activated, the light is dimmed
between 22:00 and 6:00. Please set the actual time to use this function.
• Press the + button to activate (ON) or deactivate (OFF) the function.
• Confirm the setting with the
MODE
button to return to normal mode.
• The device will automatically quit the setting mode if no button is pressed for 20 seconds.
8. Display section HISTORY
• The graph shows the measured CO
2
values of the last 24 hours clearly.
• The bar on the position “0 h” always corresponds to the current measured value of the CO
2
level (the
bar is updated every 10 seconds, together with the measured value).
7.1.2 „AL”
In this mode, the red display illumination is activated as an optical signal in the event of an alarm
when the limit value (default> 1400 ppm) has been exceeded.
You can set the alarm limit value in setting mode.
7.1.3 „on"
In this mode, you can set the display illumination to a single colour.
Choose between 7 colours in setting mode.
7.1.4 „OFF”
The backlight is off in this mode.
7.2 Setting mode
• Press and hold the
MODE
button for 3 seconds. SEL COL appears and you can use the
+
button to select
the display illumination colour for the "on" mode.
1 = WHITE
2 = LIGHT BLUE
3 = DARK BLUE
4 = PURPLE
5 = RED
6 = YELLOW
TFA_No. 31.5009_Anleit_12_20 17.12.2020 18:22 Uhr Seite 12
