10
• (Fig. XII) The handbrake (24) is a walking and parking brake at the same
time. To activate the parking brake, you must pull the brake lever (24) fully
tight and completely close the red parking lever (25), so that the brake lever
(24) remains tightened to the maximum and the brake is permanently
blocked. To release the brake, you must pull the brake lever (24) and unlock
the parking lever (25) again. If the braking effect starts to weaken, you can
carry out a fine adjustment. To do so, turn the adjusting screw (26) on the
brake grip anti-clockwise and check the braking effect again.
• (Fig. XIII) To fold up the Joggster 3, fold the footboard (19) up, release the
two locks (4) over the folding joint and the double lock (3) and swivel the
push bar (2) towards the front. Then pull the basket (1) upwards with a jerk.
To do so, use the carrying strap (27) on the basket. You can then lift up the
pushchair by the belt (27); it will then fold together.
• (Fig. XIV) Close the transport lock (28) on the frame to ensure that the
Joggster 3 does not accidentally open up again.
Safety instructions for use while jogging or inline skating
• Attach the enclosed retention strap (29) on the rear axle and pull the side
with the elastic band over your wrist (Fig. XV)!
• Place the seat in its upright position and secure your child tightly with the 5-point
harness! Give your child a helmet! Do not jog or skate with the seat lowered!
• Make sure that your child does not have any loose objects in the pushchair
that could fall out!
• Always proceed carefully and never put any other road or path users at
risk! Always be ready to brake!
• Skate and run on level surfaces only and avoid gradients and slopes of
over 5% ! Do not roll over obstacles or potholes!
• Do not jog or skate with the carry-cot or a Group 0 child’s seat!
• Increase the tyre pressure to 1.5 bar!
• Do not jog or skate in weather conditions such as storms, rain, snow, frost or darkness!
• Additional stable loads in the basket increase the anti-tilt stability!
Please use the Joggster 3 for skating only if you are already an experienced
skater. The Joggster 3 is not a “learning aid for skaters”! Please do not lean
on the pushchair or use it as a “brake”!
The Joggster 3 is equipped with the following components that are
indispensable for sports use: Adjustable brake discs on the rear axle, fixed
front wheel, fine adjustment for straight running, retention strap for the wrist,
freely attached seat cover for better shock absorption, mosquito net, height-
adjustable push bar, bumper bar and 5- point safety harness.
11
TECHNICAL DATA
Dimensions when pushchair is folded and without wheels: 78 x 54 x 30 cm
Weight: 12.9 kg - Please find a detailed parts list on our homepage www.buggy.de
CARE INSTRUCTIONS
- Clean all parts with a damp cloth.
- Do not use any caustic cleaning or lubricating agents!
- An oil spray on the folding joints and the wheel bearings will guarantee smooth running.
- You can wash the seat cover by hand at 30°.
Not suitable for a washing machine or tumble dryer!
WARRANTY CONDITIONS
The statutory provisions shall apply for justified complaints. As proof of
purchase, please keep the till receipt for the duration of the statutory period
of limitation. This term is 2 years *) and starts with the handover of the
product to you. Should any faults arise in relation to this product, they shall
involve any faults of material and manufacture that exist at the date of
transfer. Any claims shall be excluded for:
• Natural wear and damage due to excessive stress
• Damage due to unsuitable or improper use
• Damage due to faulty assembly and commissioning
• Damage due to negligent handling or maintenance
• Damage due to improper modifications to the pushchair
Faults must be notified immediately, so that no subsequent damage can be
caused!
A case for complaint or not?
• Most TFK products are produced to a large extent from aluminium and so
are rust-proof. However, some parts are also painted, galvanized or have
other surface protection. These parts may rust, depending on the level of
maintenance and stress. This can therefore not be regarded as a fault.
• Scratches are normal signs of wear and are not a fault.
• Moist textiles that are not dried can moulder and so can not be considered
as a production-related fault.
• The fading of colours due to sunshine, perspiration, cleaning agents,
abrasion or excessively frequent washing cannot be ruled out and so does not
represent a fault.
• Please check carefully at the time of purchase whether all the fabric parts,
seams, press studs and zips are sewn and function properly.
• Worn-down wheels are of course a sign of wear. Damage due to external
influences is not a fault. Slight imbalances are inevitable and do not
represent a fault. The handover check must always be carried out to prevent
inconvenient problems right at the outset. If you find a fault at a later date,
please notify your authorised dealer immediately. He will then contact us to
discuss the subsequent procedure. Any deliveries to TFK that are unnotified or
not prepaid will not be accepted.
*) valid only in the EU. In other countries according to the respective
warranty terms.
